Z Axis Probing Issues - General Discussion - Klipper

Basic Information: Printer Model: Custom CoreXY MCU / Printerboard: rPi 4B, Octopus V1.1 & FLY SHT42 klippy.log (851.2 KB) I have two issues that need to be addressed when trying to implement sensorless homing that will allow SAVE_CONFIG updates from functions like SHAPER_CONFIGURATION. This is a continuation to Problem with SHAPER_CALIBRATE & TMC2209s with Sensorless Homing 1. Updating printer.toolhead.homed_axes after single axis homing: I’m using the following code to implement TMC2

Klipper & BLTouch: How to Make Them Work Together

Anybody using a Duet board with a Klipper SBC?

Neptune 4 Plus - v1.2.2.64 firmware issues : r/elegoo

Amount of Z-axis movement is unstable - General Discussion - Klipper

Z-axis raising when using PROBE command : r/klippers

Config file with TAP. HELP! - Voron 2 - Questions - Team FDM

Z axis travel adjust - General Discussion - Klipper

Printing on the Same Line Height/Z-Axis Issues - General Discussion - Klipper

Communication timeout during homing probe + Extrude below Min Temp Errors - General Discussion - Klipper

Amount of Z-axis movement is unstable - General Discussion - Klipper